StreamProbe

Ubiquiti Camera RTSP URL Guide & Tester

Test any Ubiquiti IP camera stream instantly. Ubiquiti cameras use RTSP for live streaming — paste your URL below to verify reachability, detect codec, and check resolution without installing any software.

Secure your camera admin login

IP cameras ship with factory default credentials for initial setup only. Leaving default credentials active on any network-connected device is a serious security risk — attackers actively scan for and exploit cameras with unchanged defaults.

  1. Log in to the camera web interface using the initial setup credentials (check the sticker on the camera body or the quick-start guide).
  2. Navigate to Configuration → User Management (menu names vary by firmware version).
  3. Set a strong, unique password — at least 12 characters, mixing letters, numbers, and symbols. Do not reuse passwords across devices.
  4. Save and log back in with the new credentials to confirm the change took effect.
  5. Update your RTSP URL with the new credentials, then use CamCheck below to verify the stream is still accessible.

Ubiquiti RTSP URL pattern

The RTSP URL pattern for Ubiquiti cameras:

rtsps://<host>/<channel-id>

Replace <user>, <pass>, and <ip> with your camera's credentials and IP address. Never leave default credentials unchanged — update them and use CamCheck below to verify the stream.

Default ports

Test your Ubiquiti camera stream

Paste your Ubiquiti RTSP URL below (use your real IP and credentials). StreamProbe will connect from our servers to verify reachability, detect codec and resolution, and confirm the stream is live — no software required.

Frequently asked questions

What is the default IP address for Ubiquiti cameras?

Ubiquiti cameras typically use DHCP by default, obtaining an IP address from your router. Use SADP (Hikvision/Dahua), ConfigTool, or a network scanner to find the camera IP. Some brands also assign a default static IP during initial setup.

How do I access the Ubiquiti camera web interface?

Open a web browser and navigate to http://. For HTTPS, use https://. Log in with your admin credentials. If you forgot the password, perform a factory reset by holding the reset button. Always set a strong password on first login.

← Back to CamCheck — Test Any IP Camera